Page 72 - ingenioren

Product

safety

This is your responsibility
Always read and understand the safety information supplied with the tool and on www.atlascopco.com
All locally legislated safety rules regarding installation, operation and maintenance shall be respected at all times.

1. Check the free speed 4. Check the grinding wheel
• The measured speed at a pres- Make sure that the grinding
sure of 6.3 bars must not exceed wheel is not cracked or
the rated speed, which is marked damaged in any way.
on the grinder. • The grinding wheel
• Remove the grinding wheel and should have the correct
outer flange before checking the hole dimensions and be
free speed. Mem Mode fitted correctly on the
• Carry out checks daily. spindle to avoid unbal-
anced vibrations.
• Make sure the speed marking on the tool is legible.
• Damaged grinding
• Return the machine for repair in the event of overspeeding.
wheels must be
removed and replaced
immediately.
• Do not use dropped or damaged wheels, as these can
cause serious injuries.

2. Check the wheel guard
The wheel guard protects your health and safety.
• Always use the recommend-
ed wheel guard. 5. Check the flange and wheel
• Check that it is not Make sure that flange and wheel combinations corre-
damaged. spond to national regulations.
• Never use a grinder without • Check that the flanges are undamaged and clean.
the wheel guard. • Attach the wheel with the recommended torque.
• Position the wheel guard between yourself and the • Always disconnect the air supply when changing the
grinding wheel. wheel or adjusting the tool.
Check that the trigger is working correctly. • Test-run your grinder in a protected area after assem-
• The trigger must never be removed or fixed by tape for bling the wheel.
example. • Check that the grinder is working correctly.
• If the trigger is not working properly, make sure that it is
replaced.

Nm

3. Maximum speed
Make sure that the stated
maximum speed of the grind-
ing wheel is greater than or
equal to the speed specified Max
on the grinder. speed

72 Material removal tools