Page 21 - ingenioren

Shoptalk
Simple Facts about Liquid Filtration

Using Donaldson Fuel Filters Don’t Retighten a Lube Filter
with Biodiesel Once it Has Been Installed SHOPTALK

Donaldson fuel filtration products are To avoid cross-
compatible with OEM approved grades threading DO
(ASTM D 6571 or EN 14214) of biodiesel NOT OVER
TIGHTEN OR
blends, up to and including B20 and RETIGHTEN a
ULSD fuels. filter.

Follow These Installation Instruction for
Spin-On Engine Lube Filters
The spin-on engine lube filter is a commonly serviced
component on your vehicle. To insure normal oil filter service life
and to prevent oil leakage or possible internal engine damage,
Biodiesel, n. - a fuel comprised of mono-alkyl esters of long the following procedure should be followed when replacing
chain fatty acids derived from vegetable oils or animal fats, spin-on engine lube filters.
designated B100, and meeting the requirements of
ASTM D 6751 or EN 14214. Before Installation:
1. Unscrew and remove the old filter.
Biodiesel blend, n. - a blend of biodiesel meeting 2. Remove the old filter gasket if still attached to the base.
ASTM D 6751 or EN 14214 with petroleum-based diesel 3. Wipe the filter mounting base or head with a clean cloth.
fuel designated BXX, where XX is the volume percent of
biodiesel.
To Install a Spin-on Lube Filter:
1. If manufacturer recommends, fill new filter with oil on the
dirty side. Do not pour the oil down the clean oil center tube.
2. Apply a thin film of clean motor oil to the new filter gasket.
Using High Blends of Biodiesel
Filters that are used in special applications using high Do not use grease.
blends of biodiesel and those near B100 or unblended B100, 3. To avoid cross-threading, line up the filter threads to the
should use solvent resistant sealing materials. Continued mounting base/head carefully. Screw the new filter on until
use of standard sealing materials commonly found on the gasket contacts the base.
popular fuel filters could result in deterioration or swelling 4. Follow the instructions on the filter for final tightening torque
of the material, which may cause leaks. specification. DO NOT OVER TIGHTEN.
5. Check the gasket of the new filter to be sure it is properly
seated in the groove
Avoid Filter Plugging
Filter plugging problems can be prevented by effectively Note that not all filters require the use of tools for changing.
cleaning storage tanks before introducing biodiesel. Filter
plugging can also be minimized by using low blends of After Installation:
biodiesel and/or ensuring the biodiesel that you are using 6. Be sure the oil reaches the full level on the dipstick.
is from a quality source meeting the ASTM D 6751/EN 7. Start engine and check for leaks around the oil filter and
14214 specifications. BQ-9000 is a quality certification for drain plug. Correct the source of leaks if any are observed.
®
biodiesel suppliers who provide quality biodiesel meeting 8. Shut the engine off and recheck the oil level. Add oil if
the specification in the U.S. & Canada. needed.

Biodiesel is an alternative fuel that is rapidly growing in Check local, state and federal regulations for the proper
use. The use of biodiesel that does not meet these industry disposal of your used oil and filters.
specifications may cause problems within a fuel system.

More information on ULSD or Biodiesel can be More information is available through the
found at www.biodiesel.org Filters Manufacturers Council at:
www.filtercouncil.org/uploads/docs/TSB/English/93-3R1.pdf
Ref: Shoptalk Card F115278
Ref: Shoptalk Card F115248

www.donaldson.com Engine Liquid Filtration • 19